LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1315 (Wipers And Washers) >> Diagnosis And Testing >> Wipers and Washers >> Component Test - Windshield Wiper Motor >> Notes

Component Test - Windshield Wiper Motor: Notes

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Do not handle the windshield wiper motor roughly when diagnosing the wiper operations. Failure to follow these instructions may result in damage to the motor magnets and may render the windshield wiper motor inoperative. Rough handling of new windshield wiper motors may also damage the motor magnets.
NOTE: The windshield wiper motor component test is carried out to determine if the windshield wiper motor and module are functional and not in a software safe mode. Refer to PRINCIPLES OF OPERATION  in this article for software safe mode parameters.
NOTE: Battery voltage must remain within 10 to 15 volts to carry out the test and keep the windshield wiper motor from entering its software safe mode.
NOTE: When connecting the power and ground test leads to the windshield wiper motor terminals, care must be taken to not short the terminals between power and ground, as well as making sure the logic ground, pin 3, is always securely connected to prevent permanent windshield wiper motor module damage.

If the windshield wiper motor does not pass any of the following tests, install a new windshield wiper motor. REFER to WINDSHIELD WIPER MOTOR  in this article.

Use the SABRE Premium Battery and Electrical System Tester to test the windshield wiper motor.

Fig 1: Identifying SABRE Premium Battery And Electrical System Tester
G03891173Courtesy of FORD MOTOR CO.

To test the windshield wiper motor, remove the windshield wiper mounting arm and pivot shaft from the windshield wiper motor. REFER to WINDSHIELD WIPER MOTOR  in this article.

Disconnect the wiper motor. Connect the (1) green lead from the (2) SABRE to the battery negative (-) post. Connect the red lead (3) from the SABRE to the wiper motor (4) component side connector ground and logic ground pins 6 and 3 (3). Connect the battery positive cable (5) to the windshield wiper motor (4) component side connector battery and logic positive pins 5 and 8 (5).