LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1314 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Hood Latch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Mark the hood latch prior to the removal of the bolts.
  1. Remove the 2 hood latch bolts.
    • To install, tighten to 12 Nm (9 lb-ft).
  2. Position the hood latch up.
  3. Disconnect the hood latch release cable and remove the hood latch.
    • Lubricate the hood latch after installation.
  4. To install, reverse the removal procedure.
    • When a new hood latch is installed, the latch adjustment must be checked to make sure the latch is installed correctly.
scientia non olet · About LEMON Manuals