LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1313 (Instrument Panel And Console) >> Removal And Installation >> Floor Console >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seats as needed to remove the console.
  2. Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  3. Remove the floor console storage bin.
    1. Remove the 3 screws and the armrest.
    2. Remove the floor console storage bin screw.
    3. Remove the pin-type retainer.
      • Disconnect the electrical connectors.
  4. Remove the floor console front finish panel.
    • Pull upward from the front of the trim panel to release the retainers.
    • Disconnect the electrical connectors.
  5. Remove the floor console center finish panel.
  6. If necessary, remove the 2 screws and the floor console cup holder.
  7. Remove the 2 floor console front screws.
  8. Remove the 3 floor console rear screws.
    • To install, tighten to 4 Nm (35 lb-in ).
    9. NOTE: Lift the console from the rear and slide it rearward to release the rear seat heater ducts from the instrument panel.
  9. Remove the nut and the floor console.
    • Disconnect the electrical connector.
    • To install, tighten to 8 Nm (71 lb-in).
  10. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals