Windshield Glass: Removal
WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the cowl panel grille. For additional information, refer to FRONT END BODY PANELS .
- Remove the windshield moulding. For additional information, refer to WINDSHIELD MOULDING in this article.
- Remove the interior rear view mirror. For additional information, refer to REAR VIEW MIRRORS .
- If equipped, remove the rain sensor module.
- Remove the 2 A-pillar trim panels.
- Disconnect the windshield electrical connectors.
- Lower the front portion of the headliner.
- Using a soft brush or vacuum, remove dirt and foreign material from the pinch weld.
- Using the special tool, starting at the top center of the windshield glass, cut the urethane adhesive away from the glass and work down the sides.
- Using the special tool, distance the windshield from the body.
- Remove the dual lock windshield glass stops from the sheet metal frame.
- Using the special tool, cut the remaining urethane adhesive and remove the windshield.
- Using a soft brush or vacuum, remove dirt and foreign material from the pinch weld.
CAUTION:
Cover the instrument panel in order to prevent possible damage.
CAUTION:
Care must be used to avoid scratching the pinch weld.
NOTE:
Lubricate the existing urethane adhesive with water to aid the special tool while cutting
NOTE:
When cutting foam inside, first cut the foam dam to access the urethane adhesive