Rear Window Glass: Installation
WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
After installing the new urethane-installed rear window glass, the vehicle should not be driven until the urethane adhesive has cured. The curing time at temperatures above 13°C (55°F) and relative humidity above 50% is 12-24 hours. (Refer to the drive away chart for the cure times as the temperatures and humidity vary). Inadequate curing of the urethane adhesive may adversely affect the strength of the urethane adhesive bond.
- Dry fit the rear window glass to the existing urethane bed on the body pinch weld. Align the rear window glass in the opening for a uniform fit.
- Use tape or non-permanent marking pencil to make alignment marks on the rear window glass (preferably at the setting blocks), and the body to aid in the installation alignment of the rear window glass.
- After alignment, remove the rear window glass and moulding from the vehicle and place them on a stable work surface.
- Trim the remaining urethane adhesive on the pinch weld using only the full-cut method. In this method, most of the existing urethane adhesive is removed leaving a level bead around the entire pinch weld.
- Check the pinch weld for damaged sheet metal, raised sheet metal at the spot welds, rust or foreign material that may cause glass breakage. Clean or repair the surface as necessary.
- Use a wool applicator to apply urethane metal primer to any exposed metal on the pinch weld. Allow 6 to 10 minutes to dry.
- If reinstalling the original rear window glass, remove any excess urethane adhesive.
- Clean the inside of the rear window glass surface with an alcohol-free cleaner to make sure the ceramic-coated area is clean.
- If installing a new rear window glass, apply urethane glass prep twice around the glass surface to be prepped.
- If installing a new rear window glass, apply urethane glass primer to the same area that was prepped in the previous step. Allow 5 minutes to dry.
- Cut the urethane adhesive applicator tip to specification.
- Apply a bead of urethane adhesive to the pinch weld.
- Install the rear window glass on the pinch weld. Align the rear window glass to the body using the alignment marks while pushing downward to set the stops.
- After the urethane has cured, check the windshield seal for air or water leaks through the urethane adhesive bead and add urethane adhesive as necessary.
- Position the headliner.
- Connect the 3 rear window glass electrical connectors.
- Install the quarter trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
WARNING:
All rust found on the pinch weld must be removed and the pinch weld restored to original equipment manufacturer (OEM) specifications. If surface rust is found, remove completely down to clean, bare metal. Prime the pinch weld metal with an OEM recommended curing automotive paint primer and allow it to cure correctly. If rust has penetrated through the pinch weld metal, repair the pinch weld sheet metal at a body shop before proceeding.
CAUTION:
Wipe off the urethane glass prep immediately after each application because it flash dries. Apply deliberate strokes, making sure not to overlap the applied area
CAUTION:
Open the windows to prevent the rear window glass from being pushed out by air pressure if a door is closed.
NOTE:
The urethane adhesive must cure for a minimum of 1 hour before testing for air or water leaks.