LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1311 (Seating) >> Removal And Installation >> Seat Cushion - Rear >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

    All seats 

  1. Using a suitable tool, release the mini-buckle.
    Fig 1: Identifying Mini-Buckle
    G03999570Courtesy of FORD MOTOR CO.
  2. Release the 2 levers located at the lower outboard edges of the seat cushion, lift the cushion up and pull the cushion out.
    Fig 2: Identifying Lower Seat Cushion Releasing Latch
    G03945904Courtesy of FORD MOTOR CO.

    3. Heated seats 

  3. Disconnect the heated seat electrical connectors at both outboard sides of the seat cushion.
    Fig 3: Disconnecting Heated Seat Electrical Connectors Both Outboard Sides Of Seat Cushion
    G03999572Courtesy of FORD MOTOR CO.

    4. All seats 

  4. Remove the seat cushion.
  5. To install, reverse the removal procedure.
  6. Check the active restraint system for correct operation. For additional information, refer to SAFETY BELT SYSTEM .
scientia non olet · About LEMON Manuals