Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: LH side shown, RH side similar.

Using a suitable tool, release the mini-buckle.

Fig 1: Identifying Mini-Buckle
Courtesy of FORD MOTOR CO.
Release the 2 levers located at the lower outboard edges of the seat cushion, lift the cushion up and pull the cushion out.

Fig 2: Identifying Lower Seat Cushion Releasing Latch
Courtesy of FORD MOTOR CO.
If equipped, disconnect the heated seat electrical connectors at both outboard sides of the seat cushion.

Fig 3: Disconnecting Heated Seat Electrical Connectors Both Outboard Sides Of Seat Cushion
Courtesy of FORD MOTOR CO.
Remove the seat cushion.
Using the release lever located in the trunk, fold the appropriate seat backrest down.
Remove the nut at the bottom of the side bolster.
- To install, tighten to 11 Nm (8 lb-ft).
Pull down the lever to release the LH latch and remove the LH side bolster.

Fig 4: Removing LH Side Bolster
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.