LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1311 (Seating) >> Removal And Installation >> Seat Backrest - Rear >> Installation

Seat Backrest - Rear: Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

    40 percent backrest 

  1. Position the 40 percent seat backrest in the vehicle.
    2. NOTE: Original fasteners must be discarded and new service fasteners installed. Service fasteners can be reused.
  2. Install 2 new 40 percent rear seat backrest bolt and washer assemblies W503942-S424.
    • Tighten to 17 Nm (13 lb-ft).

    3. 60 percent backrest 

  3. Position the 60 percent seat backrest in the vehicle.
    4. NOTE: Original fasteners must be discarded and new service fasteners installed. Service fasteners can be reused.
  4. Install 2 new 60 percent rear seat backrest bolt and washer assemblies W503942-S424.
    • Tighten to 17 Nm (13 lb-ft).

    5. All backrests 

  5. Position the seat cushion in the vehicle.
  6. If equipped, disconnect the heated seat electrical connectors at both outboard sides of the seat cushion.
    Fig 1: Disconnecting Heated Seat Electrical Connectors Both Outboard Sides Of Seat Cushion
    G03999572Courtesy of FORD MOTOR CO.
  7. Align the seat cushion and release the 2 levers located at the lower outboard edges of the seat cushion, press the cushion down and fully seat the seat cushion to the retainers.
    Fig 2: Identifying Lower Seat Cushion Releasing Latch
    G03945904Courtesy of FORD MOTOR CO.
  8. Engage the mini-buckle.
  9. Check the active restraint system for correct operation. For additional information, refer to SAFETY BELT SYSTEM .
scientia non olet · About LEMON Manuals