LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1307 (Front End Body Panels) >> Removal And Installation >> Radiator Grille Opening Panel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front bumper cover. For additional information, refer to BUMPERS .
  2. Remove the 4 pin-type retainers and the radiator upper sight shield.
  3. Remove the 6 bolts and the headlamp assemblies.
    • Disconnect the electrical connectors.
      • To install, tighten to 6 Nm (53 lb-in).
      • If necessary, adjust the headlamps. For additional information, refer to EXTERIOR LIGHTING .
  4. Release the wiring harness fasteners and position the wiring harnesses rearward.
  5. Release the ambient air temperature sensor.
  6. Remove the 6 bolts, the brackets, and the radiator grille opening panel.
    • To install, tighten to 11 Nm (8 lb-ft).
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals