Cowl Panel Grille: Installation
WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
- Position the cowl panel grille and install the 6 pin-type retainers.
- Install the 2 windshield wiper and pivot arms onto the pivot shafts, install the 2 nuts, and align the blade to the heated wiper park/windshield wire lines on the windshield glass within the specification.
- Cycle the windshield wiper motor to park the windshield wiper pivot arm shafts.
- Tighten the 2 windshield wiper pivot arm nuts.
- Tighten to 25 Nm (18 lb-ft) and install the 2 wiper pivot arm nut covers.
NOTE:
Use the lower rearward clips as locators prior to installation, working from the center of the vehicle outward.
NOTE:
Do not tighten the wiper pivot arm nuts until the windshield wiper pivot arms are properly adjusted to specification.