LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1305 (MULTIFUNCTION Electronic Modules) >> Removal And Installation >> Rear Electronic Module (REM) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Prior to the removal of the module, it is necessary to upload module configuration information to the appropriate diagnostic equipment. This information needs to be downloaded into the new module once installed. For additional information, refer to MODULE CONFIGURATION .
    CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
  1. Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Position the RH rear luggage compartment trim panel aside.
  3. Remove the 3 REM nuts.
    • To install, tighten to 7 Nm (62 lb-in).
    4. NOTE: It may be necessary to position the REM rearward to access some of the connectors.
  4. Disconnect the 7 REM electrical connectors.
  5. Remove the REM.
    6. NOTE: Once the REM is installed, it is necessary to download the module configuration information from the diagnostic tool into the new module. For additional information, refer to MODULE CONFIGURATION .
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals