LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1301 (Anti-Theft - Perimeter) >> Diagnosis And Testing >> Anti-Theft - Perimeter >> Inspection and Verification >> Notes

Inspection and Verification: Notes

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern.
  2. Visually inspect for obvious signs of mechanical and electrical damage.
    VISUAL INSPECTION CHART

    Mechanical Electrical
    • Anti-theft hood switch
    • Driver door arm/disarm switch
    • Luggage compartment lid disarm switch
    • Ignition switch
    • Vehicle horn
    • Door ajar switches
    • Luggage compartment lid ajar switch
    • Central junction box (CJB) fuse 5 (5A)
    • Battery junction box (BJB) fuse(s):
      • 22 (20A)
      • 25 (40A)
    • FEM
    • REM
    • DDM
    • Connectors
    • Circuitry
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
  4. If the cause is not visually evident, connect the diagnostic tool to the data link connector (DLC) and select the vehicle to be tested from the diagnostic tool menu. If the diagnostic tool does not communicate with the vehicle:
    • check that the program card is correctly installed.
    • check the connections to the vehicle.
    • check the key switch position.
  5. If the diagnostic tool still does not communicate with the vehicle, refer to the diagnostic tool operating manual.
  6. Carry out the diagnostic tool data link test. If the diagnostic tool responds with:
    • SCP or UBP circuit fault; all electronic control units no response/not equipped, refer to MODULE COMMUNICATIONS NETWORK .
    • No response/not equipped for front electronic module (FEM), refer to MULTIFUNCTION ELECTRONIC MODULES .
    • No response/not equipped for rear electronic module (REM), refer to MULTIFUNCTION ELECTRONIC MODULES .
    • No response/not equipped for driver door module (DDM), refer to MULTIFUNCTION ELECTRONIC MODULES .
    • System passed, select FEM, REM and DDM from the main menu, retrieve and record the continuous diagnostic trouble codes (DTCs), erase the continuous DTCs and carry out self-test diagnostics for the FEM, REM and DDM.
  7. If the DTCs retrieved are related to the concern, go to the FRONT ELECTRONIC MODULE (FEM) DIAGNOSTIC TROUBLE CODE (DTC) INDEX , the REAR ELECTRONIC MODULE (REM) DIAGNOSTIC TROUBLE CODE (DTC) INDEX , or the DRIVER DOOR MODULE (DDM) DIAGNOSTIC TROUBLE CODE (DTC) INDEX  TO CONTINUE DIAGNOSTICS.
  8. IF NO DTCS RELATED TO THE CONCERN ARE RETRIEVED, GO TO SYMPTOM CHART .
scientia non olet · About LEMON Manuals