LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1297 (Exterior Lighting) >> Removal And Installation >> Headlamp Bulb >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

    High and low beam bulbs 

  1. Remove the headlamp assembly. For additional information, refer to HEADLAMP ASSEMBLY  in this article.

    2. Low beam bulb only 

  2. Remove the 4 low beam access cover screws.
  3. Remove the low beam access cover and seal.
  4. Disconnect the electrical connector.
    WARNING: The headlamp bulb contains gas under pressure. The bulb may shatter if the glass envelope is scratched or if the bulb is dropped. Handle the bulb only by its base. Avoid touching the glass envelope. Failure to follow these instructions may result in personal injury.
    NOTE: The headlamp bulb should Not be removed from the headlamp until just before a new bulb is installed. Removing the bulb for an extended period of time may affect headlamp bulb performance. Contaminants may enter the headlamp with the bulb removed from the headlamp.
  5. Remove the bulb.
  6. To install, reverse the removal procedure. High beam bulb only
  7. Remove the 4 high beam access cover screws.
  8. Remove the high beam access cover and seal.
  9. Disconnect the electrical connector.
    WARNING: The headlamp bulb contains gas under pressure. The bulb may shatter if the glass envelope is scratched or if the bulb is dropped. Handle the bulb only by its base. Avoid touching the glass envelope. Failure to follow these instructions may result in personal injury.
    NOTE: The headlamp bulb should Not be removed from the headlamp until just before a new bulb is installed. Removing the bulb for an extended period of time may affect headlamp bulb performance. Contaminants may enter the headlamp with the bulb removed from the headlamp.
  10. Remove the bulb.
  11. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals