LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1295 (Antenna) >> Removal And Installation >> Antenna Isolator Module >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the LH and RH rear quarter panel trim panels. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  3. Lower the rear of the headliner.
  4. Disconnect the antenna connector from the back glass.
  5. Disconnect the antenna isolator module electrical connector.
  6. Disconnect the antenna cable.
  7. Remove the bolt and the antenna isolator module.
    • To install, tighten to 12 Nm (9 lb-ft).
  8. To install, reverse the removal procedure.