LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1294 (Audio Unit) >> Removal And Installation >> Audio Amplifier >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

    All Amplifiers 

  1. Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Center Imaging Amplifier 

  3. Remove the driver cowl side trim panel.
  4. Remove the 2 center imaging amplifier nuts and the center imaging amplifier.
    • Disconnect the center imaging amplifier electrical connector.
  5. Audio Unit Amplifier 

  6. Remove the LH trunk trim panel.
  7. Remove the 3 audio amplifier screws and the audio amplifier and bracket.
    • Disconnect the audio amplifier electrical connectors.
    • To install, tighten to 9 Nm (80 lb-in).
  8. All Amplifiers 

  9. To install, reverse the removal procedure.