LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1290 (Charging System - General Information) >> Diagnosis And Testing >> Charging System >> Component Tests >> Generator On-Vehicle Tests - No-Load Test

Generator On-Vehicle Tests - No-Load Test

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Switch the tester to the voltmeter function.
  2. Connect the voltmeter positive lead to the generator B+ terminal and the negative lead to ground.
  3. Turn all electrical accessories off.
  4. With the engine running at approximately 2,000 RPM, check the generator output voltage. The voltage should be between 13 and 15 volts. If not, refer to the pinpoint test or GO to SYMPTOM CHART .
scientia non olet · About LEMON Manuals