LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1289 (Parking Aid) >> Removal And Installation >> Parking Aid Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

    All Sensors 

  1. Remove the rear bumper cover. For additional information, refer to BUMPERS .

    2. Ultrasonic Sensors 

  2. Disconnect the parking aid sensor electrical connectors.
  3. Release the retaining tabs and remove the 2 parking aid ultrasonic sensors.

    4. Radar Sensor 

  4. Disconnect the 2 parking aid ultrasonic sensors.
  5. Remove the rear bumper mounting bracket.
  6. Remove the 2 parking aid radar sensor bolts.
  7. Disconnect the parking aid radar sensor.
  8. Remove the parking aid radar sensor bolt and the radar parking aid sensor.

    9. All Sensors 

  9. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals