LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1283 (Heating & Ventilation) >> Heater Hose >> Auxiliary Coolant Flow Pump >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the engine air cleaner outlet tube. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
  3. Drain the engine coolant. For additional information, refer to ENGINE COOLING .
  4. Release the clamp and disconnect the upper radiator hose.
    Fig 1: Locating Upper Radiator Hose Clamp
    G03998187Courtesy of FORD MOTOR CO.
  5. Release the auxiliary coolant flow pump-to-engine hose clamp and disconnect the hose.
  6. Release the auxiliary coolant flow pump-to-heater hose and tube assembly hose clamp and disconnect the hose.
  7. Disconnect the auxiliary coolant flow pump electrical connector.
  8. Remove the 2 auxiliary coolant flow pump bolts.
    • To install, tighten to 5 Nm (44 lb-in).
  9. Remove the auxiliary coolant flow pump.
  10. To install, reverse the removal procedure.
    • Clean and lubricate the coolant hoses with plain water only, if needed.
  11. Fill the engine cooling system. For additional information, refer to ENGINE COOLING .
scientia non olet · About LEMON Manuals