Extension Housing Seal: Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure the extension housing seal is correctly installed onto the special tool and the garter spring is in the correct position.

Fig 1: Installing New Extension Housing Seal

Courtesy of FORD MOTOR CO.

Using the special tool, install the new extension housing seal.
Using the special tools, install the output flange.

Fig 2: Installing Output Flange
Courtesy of FORD MOTOR CO.
Install a new nut.
- Tighten to 131 Nm (97 lb-ft).
Fig 3: Locating Driveshaft Nut
Courtesy of FORD MOTOR CO.
Install the driveshaft. For additional information, refer to DRIVESHAFT .
Check the transmission fluid level. For additional information, refer to TRANSMISSION FLUID LEVEL CHECK in this article.