LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1273 (Automatic Transaxle/Transmission) >> Diagnosis And Testing >> Pinpoint Tests - OSC Equipped Vehicle >> Pinpoint Tests >> Pinpoint Test F: Solenoid Mechanical Failure

Pinpoint Test F: Solenoid Mechanical Failure

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Repair all other DTCs before repairing the following DTCs: P1714, P1715, P1716, P1717 and P1740.
  1. F1 ELECTRONIC DIAGNOSIS 
    • Connect the scan tool.
    • Select PARK.
    • Key in ON position.
    • Carry out KOEO test until continuous DTCs have been displayed.
    • If any of the following DTCs are present, continue with this test: P1714, P1715, P1716, P1717 and P1740.
    • Are other DTCs present for TFT or shift solenoids? 
    • Yes  : REPAIR the DTCs for TFT or shift solenoids first. CLEAR DTCs and CARRY OUT transmission Drive Cycle Test. RERUN Quick Test.
    • No  : INSTALL a new solenoid and/or body. REFER to the DIAGNOSTIC TROUBLE CODE (DTC) CHARTS  for code description. GO to  F2.
  2. F2 TRANSMISSION DRIVE CYCLE TEST 
    • Carry out transmission drive cycle test. Refer to TRANSMISSION DRIVE CYCLE TEST  in this article.
    • Does the vehicle upshift and downshift OK? 
  3. F3 RETRIEVE DTCS 
    • Connect the scan tool.
    • Select PARK.
    • Key in ON position.
    • Carry out KOEO test until continuous DTCs have been displayed.
    • Are DTCs P1714, P1715, P1716, P1717 and P1740 still present? 
    • Yes  : INSTALL a new PCM. ROAD TEST and RERUN Quick Test.
    • No  : Testing completed. If a concern still exists, REFER to DIAGNOSIS BY SYMPTOM  in this article for concern diagnosis.