LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1272 (Electronic Engine Controls) >> Removal And Installation >> Knock Sensor (KS) - 3.9L >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the intake manifold. For additional information, refer to ENGINE - 3.9 .
  3. Disconnect the 2 knock sensor (KS) electrical connectors.
  4. Remove the 2 bolts and the 2 KS.
    • To install, tighten to 20 Nm (15 lb-ft).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals