LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1272 (Electronic Engine Controls) >> Removal And Installation >> Crankshaft Position (CKP) Sensor - 3.9L >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  3. Disconnect the crankshaft position (CKP) sensor electrical connector.
  4. Remove the bolt and the CKP sensor.
    • To install, tighten to 10 Nm (89 lb-in).
    • Inspect and install a new O-ring seal as necessary.
    5. NOTE: Lubricate the O-ring seal with clean engine oil.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals