Removal and Installation
WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
- Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
- Remove the cowl panel grille. For additional information, refer to FRONT END BODY PANELS .
- Remove the 7 bolts and the cross vehicle support.
- To install, tighten to 20 Nm (15 lb-ft).
- Disconnect the engine vent hose and air bleed hose from the degas bottle and position aside.
- Disconnect the degas bottle return hose from the degas bottle and position aside.
- Remove the 2 bolts and the degas bottle.
- To install, tighten to 6 Nm (53 lb-in).
- To install, reverse the removal procedure.
- Fill and bleed the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .