LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1262 (Engine - 3.0L (4V)) >> In-Vehicle Repair >> Oil Pump >> Removal

Oil Pump: Removal

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces that enters the oil passages, coolant passages or the oil pan, can cause engine failure.
  1. With the vehicle in NEUTRAL, position it on A hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the timing drive components. For additional information, refer to TIMING DRIVE COMPONENTS  in this article .
  3. Remove the 2 bolts and the oil pump screen and pickup tube.
  4. Remove the 4 oil pump bolts in the sequence shown.
Fig 1: Removing Oil Pump Bolts In Sequence
G03955868Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals