LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1262 (Engine - 3.0L (4V)) >> In-Vehicle Repair >> Engine Mount - RH >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the upper radiator sight shield.
  3. Install the special tools and support the engine.
    Fig 1: Installing Special Tools And Support Engine
    G03995862Courtesy of FORD MOTOR CO.
  4. Remove the RH lower splash shield.
  5. Remove the RH engine mount upper nut.
    • To install, tighten to 40 Nm (30 lb-ft).
  6. Remove the 3 RH engine mount bracket bolts and detach the wiring retainer.
    • To install, tighten to 25 Nm (18 lb-ft).
  7. Using the special tools, raise the engine and remove the RH engine mount bracket.
  8. Remove the lower nut and the RH engine mount.
    • To install, tighten to 63 Nm (46 lb-ft).
  9. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals