LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1261 (Engine System-General Information) >> General Procedures >> Valve Seat Inspection >> Valve and Seat Refacing Measurements

Valve and Seat Refacing Measurements

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: After grinding valves or valve seats, check valve clearance.
  1. Check the valve head and seat.
    • Check valve angles.
    • Check margin width.
    • Refer to the appropriate article for the procedure.
    • Be sure margin width is within specification.
    Fig 1: Identifying Valve Margin Width
    G04003866Courtesy of FORD MOTOR CO.
  2. Inspect for abnormalities on the valve face and seat. Install a new cylinder head assembly if abnormalities are found.
scientia non olet · About LEMON Manuals