LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1260 (Steering Column Switches) >> Removal And Installation >> Steering Column Multifunction Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering wheel. For additional information, refer to STEERING COLUMN .
  2. Tilt the steering column all the way down and extend it all the way out.
  3. Position the front wheels to the straight-ahead position.
  4. Remove the 2 lower steering column shroud screws.
  5. Remove the lower steering column shroud.
  6. Remove the upper steering column shroud.
  7. Remove the 2 multifunction switch screws.
  8. Disconnect the electrical connector.
  9. Release the 2 tabs and slide the multifunction switch out of the clockspring.
    Fig 1: Releasing 2 Tabs And Sliding Multifunction Switch Out Of Clockspring
    G03995684Courtesy of FORD MOTOR CO.
  10. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals