LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1253 (Parking Brake & Actuation) >> Removal And Installation >> Parking Brake Actuator >> Removal

Parking Brake Actuator: Removal

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The electronic parking brake (EPB) system must be reset following the EPB system reset procedure if the battery has been discontinued. Refer to ELECTRONIC PARKING BRAKE (EPB) RESETTING  in the diagnostic article .
  1. Release the tension on the parking brake cables by connecting the diagnostic tool to the vehicle and following the diagnostic tool instructions to slacken the EPB cables.
  2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  3. Separate the EPB actuator cable from the parking brake cable and conduits at the equalizer.
  4. Release the EPB actuator cable grommet from the subframe.
  5. Disconnect the EPB actuator electrical connector.
  6. Remove the 2 EPB actuator assembly bolts.
    • To install, tighten to 23 Nm (17 lb-ft).
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals