LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1252 (Rear Disc Brakes) >> Removal And Installation >> Rear Disc Brake Shield >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the brake disc. For additional information, refer to BRAKE DISC  in this article .
    2. CAUTION: Do not use a drill larger that 6.0 mm (0.23 in) to remove the rivet from the brake disc shield.
  2. Remove the brake disc shield rivets.
    3. NOTE: If the brake disc shield cannot be removed easily, apply rust penetrant and inhibitor on the brake disc to wheel hub mating surfaces.
  3. Remove the brake disc shield.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals