LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1252 (Rear Disc Brakes) >> Disassembly And Assembly >> Rear Brake Caliper >> Disassembly

Rear Brake Caliper: Disassembly

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Use of any other than approved DOT 3 or DOT 4 brake fluid will cause permanent damage to brake components and will render the brakes inoperative.
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention immediately.
CAUTION: Brake fluid is harmful to painted or plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
  1. Remove the brake caliper. For additional information, refer to BRAKE CALIPER  in this article .
  2. Drain the remaining brake fluid from the brake caliper.
  3. Using the special tool, turn the brake piston counterclockwise.
    Fig 1: Turning Brake Piston Counterclockwise
    G03983427Courtesy of FORD MOTOR CO.
  4. Remove the brake caliper piston and piston seal