LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1242 (Noise, Vibration & Harshness) >> Diagnosis And Testing >> Noise, Vibration and Harshness (NVH) >> Pinpoint Tests >> Pinpoint Test C: ACCESSORY DRIVE BEARING HOOT

Pinpoint Test C: ACCESSORY DRIVE BEARING HOOT

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. C1 CHECK THE ACCESSORY DRIVE IDLER AND TENSIONER PULLEY BEARINGS 
    • Carry out the Vehicle Cold Soak Procedure .
    • Key in START position.
    • Place an EngineEAR probe directly on the pulley center post or the bolt to verify which bearing is making the noise.
    • Key in OFF position.
    • Is either bearing making the noise? 
    • Yes  : INSTALL a new pulley/idler. CARRY OUT Vehicle Cold Soak Procedure and TEST the system for normal operation.
    • No  : CONDUCT a diagnosis on other suspect accessory drive components.
scientia non olet · About LEMON Manuals