Adjustable Pedals With Memory Feature

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Verify the customer concern by operating the adjustable pedals.
NOTE: If the adjustable pedals are not installed on the vehicle, when a self-test is performed the module will set pedal codes.

Visually inspect for obvious signs of mechanical or electrical damage. Refer to the following chart:

VISUAL INSPECTION CHART

Mechanical	Electrical
Adjustable pedals Adjustable pedal switch	Damaged or corroded connector Damaged or corroded wiring harness Battery junction box (BJB) fuse B31 (30A). Central junction box (CJB) fuse(s): B43 (15A). B55 (5A).

If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
If the diagnostic tool does not power up, refer to the diagnostic tool manual.
Carry out the diagnostic tool data link test. If the diagnostic tool responds with:
- SCP circuit fault; all electronic control units no response/not equipped, refer to MODULE COMMUNICATIONS NETWORK .
- No response/not equipped for driver seat module (DSM), refer to SEATING .
- System passed, retrieve and record the continuous DTCs and carry out self-test diagnostics for the DSM.
If the DTCs retrieved are related to the concern, go to the DSM DIAGNOSTIC TROUBLE CODE (DTC) INDEX .
If no DTCs related to the concern are retrieved, GO to SYMPTOM CHART - ADJUSTABLE PEDAL WITHOUT MEMORY of GO to SYMPTOM CHART - ADJUSTABLE PEDAL WITH MEMORY to continue diagnostics.