Wheel Studs - E550: Installation

WARNING: This page is about a different car, the 2003 Ford RV Cutaway, 2003 Ford Econoline, 2003 Ford E550 Super Duty, 2003 Ford E450 Super Duty, and 2003 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Install the new wheel bolt aligning the serrations in the wheel adapter flange made by the original wheel bolt.
- Place four flat washers over the outside end of the wheel bolt and thread a standard wheel nut with the flat side against the washers.
- Tighten the wheel nut until the wheel bolt head seats against the back side of the wheel adapter flange.
Fig 1: Installing New Wheel Bolt
Courtesy of FORD MOTOR CO.
Remove the wheel nut and flat washers.

Fig 2: Removing Wheel Nut And Flat Washers
Courtesy of FORD MOTOR CO.
Install the wheel and tire assembly. For additional information, refer to WHEELS & TIRES article .