LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1227 (Bumper System) >> Removal And Installation >> Front Bumper Cover >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. If equipped, disconnect the fog lamp electrical connectors.
  2. If equipped, disconnect the side lamp/front turn signal electrical connectors.
  3. Remove the front fender inner splash shield screws.
  4. Remove the front fender inner splash shield pin-type retainers.
  5. Remove the front fender inner splash shields.
  6. Remove the bumper cover upper screws.
  7. Rotate the bottom of the front bumper cover upward.
  8. Apply downward pressure to the top of the front bumper cover to release the 4 retaining tabs.
  9. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals