Removal and Installation
WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
LH seat shown, RH seat similar.
- Remove the 2 rubber bolt caps.
- Remove the 2 seat mounting nuts.
- To install, tighten to 40 Nm (30 lb-ft).
- Fold the affected quad bucket seat up to the E-Z entry position.
- Remove the safety belt buckle bolt.
- To install, tighten to 40 Nm (30 lb-ft).
- Remove the 3 seat mounting bolts.
- To install, tighten to 40 Nm (30 lb-ft).
- Remove the safety belt buckle.
- Remove the quad bucket seat.
- To install, reverse the removal procedure.
- Check the active restraint system for correct operation. For additional information, refer to SAFETY BELT SYSTEM .