LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1226 (Seat System) >> Removal And Installation >> Rear Seat - 60/40 Bench, Second Row >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When removing the 60 percent seat, the 40 percent seat must be removed first to gain access to the 60 percent seat riser-to-floor nuts and bolts.

    All seats 

  1. Remove the 2 rubber bolt caps.
  2. Remove the 2 front riser-to-floor nuts.
  3. With the seat in the normal sitting position lift the seat cushion up for access to the rear seat attachment fasteners.

    4. 40 percent seat 

  4. Remove the 2 rear riser-to-floor nuts.
  5. Remove the 2 middle riser-to-floor bolts.
  6. Remove the 40 percent seat from the vehicle.

    7. 60 percent seat 

  7. Remove the rear outboard riser-to-floor nut.
  8. Remove the 2 middle riser-to-floor nuts.
  9. Remove the rear inboard riser-to-floor bolt.
    10. NOTE: When removing and installing the 60 percent seat make sure the safety belt buckles are in the DOWN position.
  10. Remove the 60 percent seat from the vehicle.

    11. All seats 

  11. To install, reverse the removal procedure.
  12. Check the active restraint system for correct operation. For additional information, refer to SAFETY BELT SYSTEM .
scientia non olet · About LEMON Manuals