LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1225 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Rear Door Latch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The RH side is shown, the LH side is similar.
  1. Remove the rear door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Position the watershield aside.
  3. Release the rear door lock lever rod.
  4. Remove the screw and position the interior rear door handle away from the door frame.
  5. Disconnect the rear door ajar switch electrical connector.
  6. Disconnect the rear door lock actuator electrical connector.
  7. Remove the 3 rear door latch screws.
    • To install, tighten to 12 Nm (9 lb-ft).
  8. Remove the rear door latch.
  9. To install, reverse the removal procedure.
    • Lubricate the door latch after installation.
scientia non olet · About LEMON Manuals