LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1225 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Hood Latch Release Handle >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the hood latch. For additional information, refer to HOOD LATCH .
  2. Remove the screw and the hood latch release handle.
  3. Remove the pin-type retainer and the LH a-pillar lower trim panel.
  4. Remove the hood latch release cable assembly screw.
  5. Release the hood latch release cable from the 4 cable locators and remove the cable.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals