LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1225 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Door Ajar Switch - Liftgate >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the liftgate trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Position the watershield aside.
  3. Remove the 3 screws and position the liftgate latch aside.
    • To install, tighten to 12 Nm (9 lb-ft).
  4. Disconnect the liftgate ajar switch electrical connector.
  5. Remove the liftgate ajar switch.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals