LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1225 (Handles, Locks, Latches And Entry Systems) >> Diagnosis And Testing >> Locks, Latches and Entry Systems >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern.
  2. Visually inspect for obvious signs of mechanical or electrical damage.
    VISUAL INSPECTION CHART

    Mechanical Electrical
    • Latches
    • Battery junction box (BJB) fuse(s):
      • 2 (30A)
      • 16 (15A)
      • 22 (20A)
      • 29 (60A)
    • Central junction box (CJB) fuse 20 (5A)
    • Circuitry
    • Relays
    • Remote keyless entry (RKE) transmitter
    • RKE keypad
    • Vehicle security module
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
  4. If the cause is not visually evident, connect the diagnostic tool to the data link connector (DLC) and select the vehicle to be tested from the diagnostic tool menu. If the diagnostic tool does not communicate with the vehicle:
    • check that the program card is correctly installed.
    • check the connections to the vehicle.
    • check the ignition switch position.
  5. If the diagnostic tool still does not communicate with the vehicle, refer to the diagnostic tool operating manual.
  6. Carry out the diagnostic tool data link test. If the diagnostic tool responds with:
    • CAN or UBP circuits fault; all electronic control units no response/not equipped, refer to MODULE COMMUNICATIONS NETWORK .
    • No response/not equipped for vehicle security module, refer to MULTIFUNCTION ELECTRONIC MODULES .
    • System passed, retrieve and record the continuous diagnostic trouble codes (DTCs), erase the continuous DTCs, and carry out the self-test diagnostics for the vehicle security module.
  7. If the DTCs retrieved are related to the concern, go to the VEHICLE SECURITY MODULE DIAGNOSTIC TROUBLE CODE (DTC) INDEX  to continue diagnosis.
  8. If DTCs are retrieved that are not found in the following Vehicle Security Module Diagnostic Trouble Code (DTC) Index, refer to the Diagnostic Trouble Code (DTC) Index in MULTIFUNCTION ELECTRONIC MODULES .
  9. If no DTCs related to the concern are retrieved, GO to SYMPTOM CHART  to continue diagnosis.
scientia non olet · About LEMON Manuals