LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1223 (Antenna) >> Removal And Installation >> Antenna >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: To access the antenna cable-to-antenna lead-in cable connection, lower the glove box door.
  1. Disconnect the antenna cable from the antenna lead-in cable and release the pin-type retainers.
  2. Remove the RH cowl side trim panel and the RH front door scuff plate trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  3. Remove the antenna mast and the antenna mast stanchion.
  4. Remove the RH front fender splash shield. For additional information, refer to FRONT END BODY PANELS .
  5. Release the antenna cable grommet.
  6. Remove the antenna cable bracket bolt and the antenna cable assembly.
    • To install, tighten to 8 Nm (71 lb-in).
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals