LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1217 (Exterior Trim And Ornamentation) >> Removal And Installation >> Running Board >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Remove the 6 running board retaining nuts.
    • To install, tighten to 25 Nm (18 lb-ft).
  3. Remove the 3 running board retaining bolts.
    • To install, tighten to 25 Nm (18 lb-ft).
  4. Remove the running board.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals