Wiper Pivot Arm - Rear: Installation
WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- Turn the wiper switch on and off to allow the rear window wiper motor to cycle and stop in the PARK position.
- Position the wiper pivot arm.
- Install the pivot shaft nut.
- Tighten to 15 Nm (11 lb-ft).
- Install the wiper pivot arm cover.
- Operate the rear window wiper for one cycle to be sure that the pivot arm is in the correct position when the rear window wiper motor is in the PARK position.
If the pivot arm is not in the correct position, remove the pivot arm and repeat Steps 1 through 4.
NOTE:
Before installation, be sure that the rear window wiper motor is in the PARK position.