LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1200 (Steering Column Switches) >> Diagnosis And Testing >> Steering Column Switches >> Inspection and Verification >> Notes

Inspection and Verification: Notes

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern.
  2. Visually inspect for obvious signs of mechanical or electrical damage.
    VISUAL INSPECTION CHART

    Mechanical Electrical
    • Multifunction switch
    • Ignition key
    • Ignition switch
    • Ignition key turning effort
    • Battery junction box (BJB) fuse 23 (30A)
    • Central junction box (CJB) fuse(s):
      • 15 (5 A)
      • 21 (5 A)
    • Circuitry
    • Instrument cluster
    • Passive anti-theft system (PATS) module
    • Wiring harness
    NOTE: For multifunction switch concerns, refer to one of the following sections:
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
  4. If the cause is not visually evident, connect the diagnostic tool to the data link connector (DLC) located beneath the instrument panel and select the vehicle to be tested from the diagnostic tool menu. If the diagnostic tool does not communicate with the vehicle:
    • check that the program card is correctly installed.
    • check the connections to the vehicle.
    • check the ignition switch position.
  5. If the diagnostic tool still does not communicate with the vehicle, refer to the diagnostic tool manual.
  6. Carry out the diagnostic tool data link test. If the diagnostic tool responds with:
    • CAN, ISO or UBP circuit fault; all electronic control units no response/not equipped, refer to MODULE COMMUNICATIONS NETWORK .
    • No response/not equipped for the instrument cluster, go to INSTRUMENT CLUSTER .
    • System passed, retrieve and record the continuous diagnostic trouble codes (DTCs), erase the continuous DTCs, and carry out the self-test diagnostics for the instrument cluster.
  7. If the DTCs retrieved are related to the concern, the Instrument Cluster Diagnostic Trouble Code (DTC) Index.
  8. If no DTCs related to the concern are retrieved, GO to SYMPTOM CHART .