LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1197 (Electronic Engine Control System) >> Removal And Installation >> Throttle Position (TP) Sensor - 4.0L SOHC >> Removal

Throttle Position (TP) Sensor - 4.0L SOHC: Removal

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the air cleaner outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING .
  3. Disconnect the throttle position (TP) sensor electrical connector.
    4. CAUTION: Failure to remove the TP sensor screws in the following manner will result in damage to the screws. First loosen the screws 1-2 full turns using a hand tool and then use a suitable high speed driver to complete the removal.
  4. Remove and discard the 2 screws and the TP sensor.
scientia non olet · About LEMON Manuals