LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1197 (Electronic Engine Control System) >> Removal And Installation >> Engine Coolant Temperature (ECT) Sensor - 4.0L SOHC >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Drain the cooling system. For additional information, refer to ENGINE COOLING .
  3. Disconnect the engine coolant temperature (ECT) sensor electrical connector.
  4. Remove the clip and the ECT sensor.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals