LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1197 (Electronic Engine Control System) >> Removal And Installation >> Cylinder Head Temperature (CHT) Sensor - 4.6L (2V) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the generator. For additional information, refer to GENERATOR AND REGULATOR .
  2. Disconnect the cylinder head temperature (CHT) sensor electrical connector.
  3. Remove the CHT sensor.
    • To install, tighten to 26 Nm (19 lb-ft).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals