LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1197 (Electronic Engine Control System) >> Removal And Installation >> Crankshaft Position (CKP) Sensor - 4.0L SOHC >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  3. Disconnect the crankshaft position (CKP) sensor electrical connector.
  4. Remove the bolt and the CKP sensor.
    • To install, tighten to 10 Nm (89 lb-in).
    5. NOTE: Be sure the sensor wiring is routed away from the battery cable.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals