Removal and Installation
WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the cupholder insert.
- Remove the 2 rear floor console front bolts.
- To install, tighten to 9 Nm (80 lb-in).
- Remove the storage compartment insert.
- Remove the 2 rear floor console rear bolts.
- To install, tighten to 9 Nm (80 lb-in).
- Disconnect the electrical connector and remove the rear floor console.
- To install, reverse the removal procedure.
CAUTION:
To prevent damage to the two plastic guide pegs located on the bottom of the console, pull the console straight up when removing.
CAUTION:
To prevent damage to the two plastic guide pegs located on the bottom of the console, install the console straight down until the pegs are correctly seated in the holes.