LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1194 (Instrument Panel And Console) >> Removal And Installation >> Floor Console - Front >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the floor console finish panel mat.
  2. Remove the floor console center finish panel screw.
  3. Remove the floor console center finish panel.
  4. Disconnect the floor console electrical connector.
  5. Remove the 2 floor console screws.
  6. Position the front seats forward.
  7. If equipped, remove the floor console bolt cover.
  8. Remove the 4 floor console bolts.
    • To install, tighten to 9 Nm (80 lb-in).
  9. Release the 2 floor console front clips.
    Fig 1: Releasing 2 Floor Console Front Clips
    G03946079Courtesy of FORD MOTOR CO.
  10. Remove the floor console.
  11. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals